Custom Milled, Choose from a wide variety of groove spacing and board thicknesses, Elite Trimworks offers MDF Grooved Sheets which can be used for Back Splashes, Cabinet Doors, Furniture, Ceilings or Wall Applications. Our V-Grooved Sheets can be ordered in panel thicknesses from 3/8" to 2" thick and the grooves can be 2", 3", 4", or 6" on center.
Our most common spacing is 4" on centre. Using the predetermined spacing insures that the beads lineup end to end for seamless wall applications. You may choose between vertical or horizontal run grooves. The Antique "V" Groove is approximately 7/32" wide and 7/64" deep, which gives a "Wide Plank" appearance.
We can groove sheets up to 5’ wide and either 2, 3, 4, 6, 8, 10, or 12ft long, between 3/8" to 2” thick.
You may also want to look at either our shiplap or tongue and groove planks that overlaps to create a seamless joint. Tongue and groove planks ½" or ⅝" thick are best suited for ceilings (to prevent sagging joints) and ⅜” thick shiplap planks are better suited for walls, being lighter and less expensive. The planks are ideal for smaller jobs that may not require a full sheet of beadboard but still require the height of a full size sheet. Should you decide to use a 3/8" thick sheets, with any bead type, they will match perfectly with our BeadBoard Rail Package that includes a pre-milled upper and lower rail, cap and shoe trim for a very rich looking wainscot beadboard application. For those of you considering installing beadboard on an un-even or tiled surface, using this custom made sheet with the rail package will give you stunning results. We can also groove these sheets in any Oak, Maple, Cherry, Mahogany etc., veneered MDF core, particle core or any board that you like. Additional images of these beaded boards can be found in the Photo Gallery.