0 items in cart
Any 7" Flexible Smooth Profile Cornice, made to order. Select the model number from our catalogue or fax in a traced drawing, or send us a sample of the cornice that you would like to match (tooling charges may apply). In the order notes or in a separate email, provides us with the required A, B, C, and D dimensions. Use a tape measure to calculate the total length required for the wall and add a foot or so for cutting. Call anytime for assistance.
* Required Minimum 6' quantity
Find helpful tips below and look through our available catalogues. Find the matching profile for your project, with over 5000 profiles available you are likely to find a perfect match.
FasteningFor best results, the use of construction type adhesive in addition to pneumatic pin nailing to wall or ceiling abutments, Mitre Bond instant adhesive on all end joints, is recommended. Use of tape or clamps may be helpful in securing material in position while adhesives bond. Nails should be kept to a minimum 3/8" from any edge.
CuttingMaterial can be cut, shaped and sanded using standard woodworking equipment. Note that the wood grain on stain grade material is only on the surface and will be eliminated if sanded.
StainingThe use of water base stain such as Minwax work wells and is recommended. Apply with brush or rag and wipe off. Additional coats may be applied if necessary to match wood. Be sure to allow first coat to dry completely before applying more stain. Finish with clear coat after staining.
PaintingPrimer coats are not recommended. Use water based Acrylic Latex Paint.When using Alkyd Enamels an exterior primer such as Kilz® is required. When using Alkyd Enamels additional drying time may be necessary. Never paint before installation. The material is flexible and the paint may crack during installation.
© 2003 - 2019 Elite Trimworks. All rights reserved.
Powered by X-Cart